Archive for Month: October 2017
Push Button Start
Take off your stock switch panel. It will look like this. You will need to switch the kill switch into the position that allows the scooter to start. Once you have done that you can now cut those wires. and tape them up. You will no longer have the kill […]
Carb/Jetting
If there’s any one component that’s more likely to go out of adjustment on your scooter (especially perhaps your Chinese scooter!), it’s the carburetor. If it does go out of adjustment lots of things can happen. It can make the scooter hard to start, it can make the scooter slow […]
150cc Short Hub/Short Axle
This article is for 150cc GY6 Long case motors only, 50cc GY6 users looking for hub and axle options go HERE. If you have just swapped over to a single shock and want a new wheel, you’re going to want a new Short Axle and a Hub. 150cc Short Axle […]
50cc Rear Wheel
To run aftermarket rear wheels on a 50cc Maddog you have a couple of options. 1st option is to get the Monstergy6 12×8 hub kit and a 12×8 wheel. This is a very good kit And runs the rear true centered. Another option so you can run a 12×7 3+4 […]
50cc Performance Upgrades
50cc Maddogs go +/- 35mph depending on the day, altitude…mood? of your scooter. Heres a few options to get you a little more oomph. Big Bore Kits 50cc Big Bore Kits come in 80cc(which is actually 72cc) and 100cc(which is 81.3cc). Both kits are direct bolt ons and work with […]
